Product Introduce제품소개

POLISHING LINECOIL POLISHING 2

COIL POLISHING

COIL POLISHING

  • 3HEAD의 경우 #1, #2HEAD 는 바탕가공을 한 후 고운 MASCH SAND BELT로 마무리 가공합니다.
  • PRESSING 압력은 잔류치의 부하에 따라 조정합니다.
  • BASIC은 NO.4가공으로 하고 그 위에 COIL POLISHING작업을 하면 깨끄스한 H/L무늬를 얻을 수 있습니다.
  • SHEET 가공시에는 BACK ROLL과의 간격조정이 무엇보다 중요합니다.
  • For 3 Head, #1 and #2 Head are finished with #3 Head(fine Mash Sand Belt) after base machining.
  • The pressure is adjusted according to the load of the residual value.
  • Basic is No.4 machined (#1, #2) and if you apply Polising(#3) on top of it, you can get a clear Hair Line pattern.
  • When processing Sheet, it is most important to adjust the interval with Back Up Roll.

  • ▨ Wet Belt Sanding machine (No.4 3Head)

  • ▨ Hair Line Machine (4 Head)

SHEET POLISHING LINE

  • 습식 H/L 경우 고압 WATER NOZZEL 장착
  • SAND PAPER 장력장치 : AIR BREAK설치
  • AIR SHAFT 적용 SAND PAPER 교체가 편리하다.
  • 배면을 SCRATCH하여 잔류응력을 제거합니다.
  • 작업을 하지 않은 경우 BY-PASS기능이 있어 편리합니다.
  • SAND BELT 장력유지 기능
  • 외팔보 처짐 방지용 STOPPER 장치가 부착되어 있습니다.
  • Sandpaper tension device air mount(sandpaper tension retention function)
  • It is convenient to replace sandpaper with and air shaft.
  • It is convenient to have a press device for each head
  • Backup Roll Mounting Brush Roller for Dust Removal Apply dust collector for dry headline equipment
  • Installation of high-pressure water nozzles for wet headlines A residual stress is removed by scratching the bottom part.
  • It is equipped with a stopper device that prevents the cantilever from sagging.
  • Convenient non-operational bypass feature

  • ▨ Hair Line Machine (4 Head)

  • ▨ Bottom Surface Scratch machine (2Head)